Daewoo DSA-100L Instrukcja Użytkownika Pobierz pdf (Strona 13)

page 13

Release box (for single-wing version, this may have to be reversed, depending on which side the gate is hinged)

180°

reversed

L=b+c+10 (table 1, page 2)

Release box open

Fitting the release box to the gate wing

To establish the fixing points on the gate wing:

With the spindle fully extended, connect the hinged gate operator in alignment with the release box and mark the

position. Open the release box and drill 2 holes centrally within the elongated holes (6 mm dia. drill). Make the release

box and the drive operator secure, then make a test run. Carry out any necessary fine adjustment via the elongated

holes. Remove rotary latch. Drill the outer hole and then screw the centrally located screw into this drill hole. This will

prevent the box from sliding sideways. Push rotary latch back in again. Place on washer and tighten hexagon nut until

rotary latch is sluggish to operate.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Brak uwag

Daewoo DSA-100L Instrukcja Użytkownika Strona 13